Mitsubishi MXZ-4E80VAD, Installation Manual

Page: 5 / 12

En-4
2-1. INSTALLING THE UNIT
2-2. CONNECTING WIRES FOR OUTDOOR UNIT
• Be sure to fix the unit’s legs with bolts when installing it.
• Be sure to install the unit firmly to ensure that it does not fall by an earthquake or a gust.
• Refer to the figure in the right for concrete foundation.
• Do not use the drain socket and the drain caps in the cold region.
Drain may freeze and it makes the fan stop.
• Remove the tape on the panel when opening the package. (DO NOT remove the LABELS on the panel.)
1) Remove the service panel and the cable cover.
2) Pass the indoor/outdoor unit connecting wire (B) and power supply cord
(A) through the grommet. Loosen terminal screw, and connect indoor/
outdoor unit connecting wire (B) from the indoor unit correctly on the
terminal block. Be careful not to make mis-wiring. Fix the wire to the
terminal block securely so that no part of its core is appeared, and no
external force is conveyed to the connecting section of the terminal block.
3) Firmly tighten the terminal screws to prevent them from loosening. After
tightening, pull the wires lightly to confirm that they do not move.
4) Perform 2) and 3) for each indoor unit.
5) Connect power supply cord (A).
6) Fix indoor/outdoor unit connecting wire (B) and power supply cord (A)
with the cable clamps. Route the cables or wires so as not to deform the
service panel. Otherwise, rainwater may enter the outdoor unit.
7) Close the service panel and the cable cover securely. Make sure that
3-2. PIPE CONNECTION is completed.
• After making connections between both power supply cord (A) and
indoor/outdoor unit connecting wire (B), be sure to fix both cable and
wire with cable clamps.
Connecting order
• Connect the terminal block in following order.
Fix here with
M10 bolts.
Make the setting
depth deeper.
Make width wider.
Anchor leg
30
or
less
Anchor bolt length
Anchor bolt pitch
(Unit: mm)
5E100VAD
Terminal block
for power supply
DR DR DR DR
Power supply
Terminal block for
indoor/outdoor unit
600
370
2. OUTDOOR UNIT INSTALLATION
Service panel
Screws
Cable
cover
Cable clamp
MXZ-5E100VAD
A
→B→C→D→
E
→P→DR
MXZ-4E80VAD
A
→B→C→D→P→DR
Terminal block for DRED interface
Wire-to-wire connector
WG79A696H02_en.indd 4 2016/04/21 14:46:38