14
6. Maintenance
Dry well in the sun
(The performance of
the filter renews with
soaking, and the
photocatalytic effect of
the sunlight removes
remaining odorants)
Hose with lukewarm water
when excessively soiled.
Dry well.
Remove grit with
vacuum cleaner
Remove the front panel and pre-filter.
1
Remove the photocatalytic filter.
2
Clean the pre-filter.
3
Floating element
Do not remove or dismantle.
Fit the photocatalytic filter.
4
Attach the pre-filter and front panel.
5
Remove the front panel and pre-filter.
1
Remove the photocatalytic filter.
2
Soak the photocatalytic filter in water.
3
Dry the photocatalytic filter.
4
Fit the photocatalytic filter.
5
Attach the pre-filter and front panel.
6
Water tank · Main unit
Wipe with a soft cloth.
Cleaning
Once every three months
Pre-filter
Debris clogging the pre-filter reduces
the effectiveness of the dehumidifier.
Clean once every 2 weeks.
Once every two weeks
Do not use detergents, cleaning agents for heat exchange equipment, abrasive powders, chemically treated
dusters, gasoline, benzene, thinners or other solvents, as they can damage the unit or the water tank, which
may result in leakage.
¡
Stains may remain on the filter, but should
not affect performance.
¡
The filter can be soaked for a total of eight
times. After that, replace with a new filter.
Do not use detergent or hot water.
Also, do not brush or rub while soaking
as this may damage the filter.
Do not hang with pegs as this may
damage the filter.
Do not use the filter while wet.
Maintenance
Photocatalytic filter
Soaking the filter in water
, and leaving it to dry
in the sun renews the performance and
prolongs service life. Perform this every three
months.
Soak in cool to
lukewarm water for
30 minutes.
¡
The unit draws in dust present in the air, and
this may cause the tank
to gradually
become dirty
. If the dirt does not come off
easily, wash with cold or warm water, then
wipe with a soft, dry cloth.
¡
Mildew may form in the tank unless kept
clean.