Mitsubishi Lancer Evolution IV, Workshop Manual, Page: 252 / 391

REAR SUSPENSION –
Rear Suspension Assembly
34-4
REAR SUSPENSION ASSEMBLY
REMOVAL AND INSTALLATION
Pre-removal Operation
(1) Center Exhaust Pipe Removal
(Refer to GROUP 15.)
(2) Trunk Room Side Trim Removal <GSR>
(3) AYC Fluid Draining
(Refer to GROUP 27 – On-vehicle Service.)
Post-installation Operation
(1) AYC Fluid Refilling and Bleeding
(Refer to GROUP 27 – On-vehicle Service.)
(2) Center Exhaust Pipe Installation
(Refer to GROUP 15.)
(3) AYC Operation Check
(4) Parking Brake Cable Stroke Check
(Refer to GROUP 36 – On-vehicle Service.)
(5) Wheel Alignment Check and Adjustment
(Refer to P.34-3.)
1
3
4
5
6
7
9
10
11
12
13
14
15
16
17
Unit: Nm {kgf
@
m}
44 {4.5}
108 – 127 {11.0 – 13.0}
54 {5.5}
88 {9.0}
93 {9.5}*
88 {9.0}
15
8
2
15
29 – 34
{3.0 – 3.5}
25 {2.6}
34 {3.5}
25 {2.5}
69
{7.0}
Toe control bar
EVOLUTION-V RS
137 – 156 {14.0 – 16.0}*
59 – 68 {6.0 – 7.0}*
Removal steps
1. Fuel filler cap
2. Bolt
3. Filler neck protector
4. Cap
5. Shock absorber mounting nut
A
A
"
6. Brake caliper assembly
7. Rear speed sensor <vehicles with
AYC>
8. Brake disc
9. Parking brake cable end (Refer to
GROUP 36.)
10. AYC fluid line connection <vehicles
with AYC>
A
B
" "
B
A
11. Propeller shaft connection
12. Upper arm mounting bolt
13. Trailing arm mounting bolt
14. Toe control arm mounting bolt
A
C
" "
A
A
15. Crossmember mounting bolt
16. Differential support assembly
mounting bolt
17. Rear suspension assembly
Caution
The parts marked with * should be first temporarily
tightened, then torqued to specification with the
vehicle on the ground in unloaded condition.