Mitsubishi FUSO FH 1997, Service Manual

Page: 144 / 200

10-3
10
●
Work before removal and after installation
Õ
P10-3
●
Removal sequence
1 Battery cable
ë
2 Pressure cap (Surge tank)
3 Radiator drain plug
^
Gr 14
4 Crankcase drain plug
^
Gr 14
5 Transmission assembly
^
Gr 22, 23
6 Air hose
^
Gr 14
7 Suction hose
^
Gr 14
8 Supply hose
^
Gr 14
9 Power steering oil hose
10 Power steering oil hose
11 Nylon tube (Intake silencer)
12 Glow relay
13 Cab bridge
^
Gr 42
14 Fuel feed hose
15 Fuel return hose
A : Wheel chock
WARNING
–
• You must insert blanking plugs into fuel feed hose 14 and fuel return hose 15 after you remove them and
secure them at a higher level than the fuel tank to prevent fuel from flowing out of them. Otherwise a fire might
be caused.
• You must make sure that the engine coolant is cold before draining it so as not to scald yourself.
• It is dangerous to open pressure cap 2, when the coolant temperature is high, without taking due care because
the hot water would spray out. Be sure to cover the pressure cap with a cloth and loosen slowly to bleed the
pressure before opening fully.
●
Installation sequence
Follow the removal sequence in reverse.
◆
Service procedure
●
Work before removal and after installation
• Discharge, charge, and air bleeding of engine coolant
^
Gr 14
• Discharge, charge, and air bleeding of oil
^
Gr 37
• Air bleeding of fuel system
^
Gr 13