Mitsubishi FUSO FH 1997, Service Manual

Page: 133 / 200

01-36
Power Steering Fluid
Ê
Tightening torque
Unit : N·m {lbf.ft, kgf·m}
Location Parts to be tightened Tightening torque Remarks
4
Oil pipe 66.69
±
12.75 {49
±
9.4, 6.8
±
1.3} —
LUBRICATION
02482
[Inspection and replenishment]
• Straighten the front wheels and stop the engine.
• Remove filler cap 2 of power steering oil tank 1 by turning the filler cap
counterclockwise.
• Wipe off the fluid sticking to dipstick 3 on filler cap 2. Replace the filler
cap.
NOTE
Check the fluid level without screwing on filler cap 2.
• Carefully lit up filler cap 2 and check the fluid sticking to dipstick 3 to
make sure that the fluid is at a point between the end and F on the
dipstick. If the level is low, add fluid.
• After inspection install filler cap 2 by turning it clockwise.
WARNING
–
Close filter cap 2 firmly; otherwise power steering fluid will leak
and could catch fire. Also wipe up spilled fluid.
CAUTION
–
If the fluid level is far below the recommended range, the fluid
may be leaking.
-
Fluid
Location Points of application Kinds Quantity
1
Power steering oil tank Automatic transmission fluid
(DEXRON or DEXRON II type)
Between
end and F
on filler
cap
dipstick
[Replacement]
• Drainage
• Jack up the front wheels.
• Disconnect oil pipe 4 connected to the power steering booster.
• Turn the steering wheel fully left and right repeatedly, and drain the
fluid from the power steering booster.
• After draining the fluid, tighten oil pipe 4 at specified torque.
12603
4
2
1
3