Mitsubishi ECLIPSE 2011, User Manual, Page: 65 / 494

2-30
Seat and restraint systems
2
NOTE
●
In order to secure a child restraint systems compatible
with the LATCH system, use the lower anchor points in
the rear seat. It is not necessary to use the vehicle’s seat
belt.
2. Open the rear hatch. Remove the rear shelf panel. Refer to
“Rear shelf panel” on page 3-178.
3. Cut out the notch (F) in the cargo floor carpet by hand,
then lift the carpet.
WARNING
!
●
If there is any foreign material in or around the
lower anchors, remove it before installing the child
restraint system. Also, make sure the seat belt is
away from, not looped through or otherwise inter-
fering with, the child restraint system. If foreign
matter is not removed and/or the seat belt interferes
with the child restraint system, the child restraint
system will not be secured properly, could detach
and move forward in the event of sudden braking or
an accident, and could result in injury to the child or
other vehicle occupants.
●
When the vehicle is moving, do not adjust the seat
where the child restraint system is installed.
In an ECLIPSE, install a tether strap in accordance with steps 2 to
4 shown hereafter.
* - Rear of the vehicle
BK0115900US.book 30 ページ ２００９年１０月２７日 火曜日 午後１２時１分