Mitsubishi ECLIPSE 2011, User Manual

Page: 297 / 494

5-8
Comfort controls
5
NOTE
●
When the “ ” or “ ” position is selected, you cannot
turn the air conditioning off or use the recirculation posi-
tion.
This prevents the windows from fogging up.
●
When the mode selection dial is set to a position other
than “
” or “ ”, the air selection will automatically
change to outside air. The air conditioning will revert to
the previous condition in which the “
” or “ ” posi-
tion was not selected.
●
When the temperature control dial is set to the “MAX
A/C” position, the air selection will be automatically set
to the recirculation position.
●
If the temperature dial is set to any position other than
“MAX A/C”, outside air will always be used when the
ignition switch is turned on.
●
When the coolant temperature rises above a certain point,
the air selection is automatically switched to the
recirculation position and the indicator light (A) turns on.
When this occurs, the system will not switch to the out-
side air position until the coolant temperature goes down,
even if the selection switch is pushed.
Air conditioning switch
N00731000319
Push the switch, and the air conditioning compressor will turn
on. The air conditioning indicator light (A) will come on.
Push the switch again and the air conditioning compressor will
stop and the indicator light (A) goes off.
CAUTION
!
●
Using the air conditioning slightly increases the
engine idle speed. Therefore, make sure your foot is
firmly on the brake pedal when shifting the
transaxle into drive.
(Green)
BK0115900US.book 8 ページ ２００９年１０月２７日 火曜日 午後１２時１分