Mitsubishi Eclipse 1990, Service Manual

Page: 2030 / 2103

SRS
Air Bag Modules and Clock Spring
AIR BAG MODULES AND CLOCK SPRING
52400240022
Caution
1.
Never attempt to disassemble or repair the
air bag module or clock spring. If faulty,
replace it.
2. Do not drop the air bag module or clock
spring or allow contact with water, grease
or oil. Replace it if a dent, cracks,
deformation or rust are detected.
3. The air bag modules should be stored on
a flat surface and placed so that the pad
surface is facing upward.
Do not place anything on top of bag
modules.
4.
Do not expose the air module to
temperature over
5. After deployment of an air bag, replace the
clock spring.
6. Wear gloves and safety goggles
handling an air bag that has
7. An undeployed air bag module should only
be disposed of in accordance with the
specified procedures. (Refer to
REMOVAL AND INSTALLATION
bag module (Driver’s side), Clock spring>
Operation
l
Set the steering wheel and the front wheels to
the straight ahead position, and then remove the
ignition key.
41
1. Negative battery cable
l
Post-installation inspection
2.
Air bag module (Driver’s side)
1. Negative battery cable
tion
3. Steering wheel
4. Column cover lower
2. Air bag module (Driver’s side)
5. Clock spring and body wiring har-
l
Pre-installation inspection
ness
connection
6. Clock spring
l
Pre-installation inspection
TSB Revision
,
5
4
4
Clock spring removal
steps
l
Post-installation inspection
Air bag module (Driver’s side)
removal steps