Mitsubishi Eclipse 1990, Service Manual

Page: 1913 / 2103

Rotating wheel
marks
FRONT SUNROOF SUNSHADE/REAR SUNROOF
SUNSHADE INSTALLATION
(1) Install the front sunroof sunshade first by inserting the
slide blocks on the right side of the sunshade into the
lower slide position of the right guide assembly.
(2) Push the sunshade slide blocks on the left side of the
sunshade into the sunshade to allow the front sunroof
sunshade to drop into position. Once in position, engage
the slide blocks into the lower channel of the left guide
assembly.
(3) Push the front sunroof sunshade to full forward position.
(4) Position the rear sunroof sunshade so that the stop tabs
are against the stop bumpers on the guide assembly.
Engage the right side slide blocks of the upper half of
the sunshade into the upper channel on the right guide
assembly. Engage the slide blocks on the left side of
the sunshade into the upper channel in the left guide
assembly.
(5) Slide the sunshade back and forth to check that it functions
smoothly.
SUNROOF CONTROL UNIT INSTALLATION
(1) Look into the “viewing windows” while turning the rotating
wheel. Turn the rotating until the white timing marks
appear. When the white timing marks appear in the “view-
ing windows” at the same time; stop turning the rotating
wheel.
(2) Close the sunroof fully. “the timed sunroof control
unit. Make sure that the sunroof cable is properly-inserted
into the control unit.
(3) Insert a flat-tipped screwdriver, place it on the tab, and
press it to the right, being careful not to pinch wiring.
GLASS SEAL INSTALLATION
(1) Starting at the rear center of the sunroof glass, begin
installing the seal by pushing it onto the edge of the
glass panel and gently pulling on it while” installing.
(2) Approximately 102 mm (4 in.) before completing installa-
tion, lay the end of the seal over top of
of the seal. Cut the seal so there ‘is an extra. 3.18 mm
in.) of the seal past the where the seal lines
up with the beginning of the
seal.
(3) Apply the specified adhesive to the
joint area where
two ends of the seal meet.