GB
Fig. -1
ijĴijįĶ
ijĴIJįĶ
F
H
C
E
B
D
ĶĹ
ij
G
Fig. -
A
K
J
I
100
(mm)
PKFY-P·VHM-E
Fig. -
A
C
D
E
B
A
Sleeve
B
Hole
C
(Indoors)
D
Wall
E
(Outdoors)
. Installing the indoor unit
.1. Check the indoor unit accessories (Fig. -1)
The indoor unit should be supplied with the following accessories.
PART NUMBER
ACCESSORY
QUANTITY
LOCATION OF SETTING
32, 40, 50
1
Mount board
1
Fix at the back of the unit
2
Tapping screw 4
×
35
12
3
Felt tape
3
4
Band
3
5
Block of cushion
1
.. Installing the wall mounting fixture
..1. Setting the wall mounting fixture and piping positions
►
Using the wall mounting fixture, determine the unit’s installation position
and the locations of the piping holes to be drilled.
Warning:
Before drilling a hole in the wall, you must consult the building contractor.
PKFY-P·VHM-E (Fig. -)
A
Mount board
1
B
Indoor unit
C
Bottom left rear pipe hole (ø65)
D
Bottom right rear pipe hole (ø65)
E
Knockout hole for left rear hole (70 × 310)
F
Bolt hole (4-ø9 hole)
G
Center measurement hole (ø2.5 hole)
H
Tapping hole (77-ø5.1 hole)
I
Hole centre
J
Align the scale with the line.
K
Insert scale.
... Drilling the piping hole (Fig. -)
►
Use a core drill to make a hole of 75-80 mm diameter in the wall in the
piping direction, at the position shown in the diagram to the left.
►
The hole should incline so that the outside opening is lower than the
inside opening.
►
Insert a sleeve (with a 75 mm diameter and purchased locally) through the
hole.
Note:
The purpose of the hole’s inclination is to promote drain flow.
1
2
3
4
5
RG79D840H01_en.indd 3
2012/10/25 (木) 午後 4:10:29
