Mitsubishi AL2-14MR-A, Hardware Manual

Page: 23 / 434

α
2 Simple Application Controllers
Installation 3
ENG-13
ENG
3. Installation
3.1 Installation Mounting Notes
The
α
2 Series’ safe design means the user can install it almost anywhere but please take
the following points into consideration.
• Do not install in areas with excessive or conductive dust, corrosive or flammable gas,
moisture or rain, excessive heat, regular impact shocks or excessive vibration. Do not
place in water or let water leak onto the controller.
• Do not allow debris to fall inside the unit during installation.
• Keep as far as possible from high-voltage cables and power equipment.
• The
α
2 Series Controller must be installed in cabinets which are designed for the
assembly of devices complying to DIN 43880 or in a control box
Figure 3.1: Mounting Arrengement.
• Use size M4 screws when mounting by screw holes.
• The connectors must be covered to prevent injury from contact with “live” wires.
• Leave a minimum of 10mm of space for ventilation between the top and bottom edges of
the
α
2 Series Controller and the enclosure walls.
• Do not disassemble the
α
2 Series controller.
Note;
• Refer to chapter 6 when installing or removing the AL2-EEPROM-2.
• Refer to chapter 7 when installing or removing the AL-232CAB.
• Refer to chapter 8 when installing or removing the AL2-GSM-CAB.