Mitsubishi AJ65SBT-64AD, User Manual

Page: 34 / 72

4 - 3
MELSEC-A
4 SETUP AND PREPARATION BEFORE OPERATION
4.3 Name of Each Part
The name of each part in the AJ65SBT-64AD is shown.
PW RUN L RUN L ERR. CH1 2 OFFSET GAIN
MITSUBISHI A
J65SBT-64AD
DA DG +24V 24G
DB SLD (FG)
TEST
TEST V+ I+
AG
V+ I+
CH1 CH2
SELECT
SET
STATION NO. B RATE
40 20 10 8 4 2 1 4 2 1
ON
DA DG
1 3 5 7
24G
DB SLD
2 4 6
(FG)
+24V
FG1
9 11 13 15 17 19 21 23 25
8 10 12 14 16 18 20 22 24
TEST
TEST
V+ I+ V+ I+ SLD AG
3 4
(FG1)
COM
SLD
COM
V+ I+
V+ I+
COM SLD COM
CH3 CH4
COM COM
SLD COM COM V+ I+ V+ I+
1) 2)
3)
4) 5)
6) 7)
2-piece
(CC-Link
communication
section)
Direct-coupled
(Analog I/O section)
[Terminal numbers and signal names]
Number
Name and
appearance
Description
PW LED
ON : Power supply on
OFF: Power supply off
Normal mode
On : Normal operation
Flashing : 0.1s intervals indicate an input range error.
Off
: 24VDC power supply shutoff or watchdog timer error occurred.
RUN LED
Test mode
On : Indicates that the SELECT/SET switch is in the SET position.
Flashing : 0.1s intervals indicate that the input range setting is not any of
"user range settings 1 to 3".
0.5s intervals indicate that you attempted to make offset/gain
setting outside the setting range.
Off : Indicates that the SELECT/SET switch is in the SELECT or
center position.
L RUN LED
On : Normal communication
Off : Communication cutoff (time expiration error)
1)
Operation status
display LED
L ERR. LED
On : Indicates that transmission speed setting or station number setting is outside
the range.
Flicker at fixed intervals : Indicates that transmission speed setting or station number
setting was changed from that at power-on.
Flicker at unfixed intervals : Indicates that you forgot fitting the termination resistor or the
module or CC-Link dedicated cable is affected by noise.
Off : Indicates normal communications.
Normal mode Normally OFF.
2)
Offset/gain adjusting
LEDs
CH
OFFSET
GAIN
Test mode
The LEDs lit change every time the SELECT/SET switch is moved to
SELECT. (Refer to Section 4.4.)
3) SELECT/SET switch Used to make offset/gain setting in the test mode.