Mitsubishi 1993 3000GT, Technical Information Manual

Page: 204 / 216

After the following procedures have been completed, the
SECURITY lamp illuminates for about 20 seconds, and
when illumination stops, the system is armed.
(1) Pullout the ignition key from the key cylinder.
(2) Open a door. (The other door is locked.)
(3) Lock the door with the key or the keyless-locking
method.
(The central door locking system will then function to
lock all doors.)
NOTE
(1) The system is set regardless of whether the
hood and tailgate are open or closed, and is
armed as soon as the lamp goes out.
(2) While the timer is functioning (approximately 20
sec.), it is not reset even if the hood or tailgate
is opened and closed.
The system will be disarmed,
(1) If the key is used to unlock a door.
(2) If the system is armed while the driver is still in the
vehicle, the system can be disarmed by inserting
the ignition key and turning it to the ACC or ON
position.
(3) If the door is unlocked while closing the door or the
door is ajar.
(4) If the door is unfastened while the SECURITY lamp
illuminates.
(5) If, after the keyless warning is set, the door on the
driver's side or passenger's side is locked but not
completely closed (door-ajar).
(1) If an attempt is made to open a door, the tailgate or
hood, without using the key, while the system is
armed, the horn will sound intermittently for
approximately 30 sec.
Furthermore, the starter circuit is interrupted at this
time also, making starting of the engine impossible.
(2) If a further attempt at forcible entry is made after the
first 30 sec. alarm has finished, the 30 sec. alarm
will be activated again.
7-32
ELECTRICAL -
Theft-alarm System
ARMING THE SYSTEM
DISARMING THE SYSTEM
ACTIVATING THE ALARM
DEACTIVATING THE ALARM
(1) To deactivate the alarm, insert the key into the
door's key cylinder and turn the key.
(2) The alarm is deactivated and the system is disarmed
when the tailgate is unlocked with the key.
CHECKING THE SYSTEM OPERATION
The activation/operation of the system can be checked
by following the steps below.
(1) Turn the ignition key to the ON position and then use
the power-window switch to fully open the window
on the driver's side.
(2) Turn the ignition key to the LOCK position and then
remove the key from the ignition.
(3) Open only the driver's door, and close all the other
doors, as well as the hood and the tailgate.
(4) Lock the driver's door with the key or the keyless-
locking method.
(5) All doors will then be locked, and the SECURITY
lamp (within the combination meter) will illuminate;
check to be sure that illumination stops in about 20
seconds.
(6) After about two seconds have passed after the
SECURITY lamp illumination stopped, reach through
the window of the driver's door, pull up the lock lever
to unlock the door, and then open the door.
(7) Check to be sure that, when the door is opened, the
horn starts sounding.
(8) To stop the alarm, insert the key into the door's key
cylinder and turn the key.
NOTE
To check the alarm for the opening of the tailgate or
hood, open the tailgate (or the hood) by using the
remote tailgate release lever (or the hood release
lever), located on the driver's side either before the
alarm is activated by the opening of a door, or after
the finish of the first 30 sec. alarm.