Mitsubishi MOTORS Pajero, Owner'S Manual

Page: 221 / 377

To listen to a CD
E00709601961
The CD can be loaded or ejected by pressing the
LOAD button (15) or the eject button (7) even if
the audio system power is off.
1. Press the PWR button (2) to turn the audio
system on and off. The system turns on in
the last mode used.
2. Press the CD button (4) to enter CD mode.
The autochanger will start playback if the
CD is already in the autochanger.
3. To stop the CD, turn off the power by press-
ing the PWR button (2) or change over to ra-
dio mode by pressing the AM/FM button (1),
or eject the disc by pressing the eject button
(7).
NOTE
l To adjust the volume and tone, refer to “To
adjust the volume” on page 5-27 and “To ad-
just the tone” on page 5-27.
l As many as 6 CDs can be inserted into the
CD autochanger.
l For information concerning the handling of
the compact discs, refer to “Handling of com-
pact discs” on page 5-65.
To set discs
To set a single disc
1. Press the LOAD button (15) briefly.
2. The autochanger will show “WAIT” on the
display and start making itself ready for disc
loading.
3. When the autochanger is ready for disc load-
ing, the indicator light (A) will come on and
the display will show “LOAD DISC (1~6)”.
4. Insert a disc into the disc loading slot.
NOTE
l If there are multiple empty slots, you can se-
lect your desired slot by pressing the DISC
buttons (16 or 17).
l If you do not insert a disc for about
15 seconds after the autochanger starts stand-
ing by for loading, the loading standby mode
will be cancelled.
To set all the discs
1. Press the LOAD button (15) for 2 seconds or
longer (until you hear a beep).
2. The autochanger will select the lowest-num-
bered empty slot and switch to loading stand-
by mode.
3. When the display shows “LOAD DISC
(1~6)”, insert a disc. The autochanger will
then automatically select the next empty slot
and enter loading standby mode.
4. Repeat the above-described steps until every
slot contains a disc. Playback will then begin
with the disc that you inserted last.
NOTE
l If you press the LOAD button (15) again
while the autochanger is in loading standby
mode, the loading standby mode will be can-
celled.
To eject discs
To eject a single disc
Press the eject button (7) briefly to eject the current-
ly selected disc.
NOTE
l If you press the eject button (7) while the dis-
play is showing “LOAD DISC (1~6)”, the
loading standby mode will be cancelled and
the next disc will be ejected.
For pleasant driving
5-38
5
OBKE12E1