Eng-4
3. Remove the terminal block cover (VL-
50ES
2
-E only)
Terminal block cover
4. Before installation
■ Mounting position diagram (seen from inside)
1. Remove the mounting plate.
Remove the tape on the back of the unit and
then remove the mounting plate.
- In order to protect the drain pan end, lay the
underlay as shown in the figure below. (Use a
package pad.)
- To prevent scratching of the unit, lay down a
material such as cardboard.
2. Remove the panel.
As shown in the figure below, hold both ends of
the panel and pull toward you.
- After removing the panel, make sure screws
or other items do not get inside the unit.
Drain pan end
Underlay
Panel
50
mm
or
more
Unit (mm)
151.5
223.5
216
245
40.5
39.5
21
11.5
26.5
20
×
8
＝
160
300
200
184
210.5
522
182
193
310
360
125
Mounting plate
Center line
Air
supply/exhaust
hole
(ø120 wall hole)
Mounting plate temporary fixing hole
position (For horizontal mounting)
Unit hanging screw
position
(For vertical mounting)
Unit hanging screw position
(For horizontal mounting)
Mounting plate
temporary fixing hole
position
(For vertical mounting)
Edge of main unit
Mounting hole 53 – ø6
Power and connection
cable pullout area
(VL-50ES
2
-E only)
min.
min.
(min.)
(min.)
