5. NetCommand IR Control
57
To perform this procedure, you need:
The remote controls for both the TV and the
•
device you want to control.
An IR emitter cable available from Mitsubishi
•
.
Note:
To set up an A/V receiver, see “Setting Up A/V
Receiver Control,” page 62.
Connect and position the IR emitters for the
1.
devices you wish to control. See “IR Emitter Place-
ment” on the opposite page.
Set the
2.
TV’s
remote control to
TV
mode and power
on the TV.
Open the NetCommand
3.
Learn
screen as follows:
If working from the
•
New Device Found
screen
after the device is first detected, highlight
NetCommand
and press
ENTER
to open the
Learn
screen for the device.
If performing NetCommand setup at any time
•
after the device has been recognized through
Auto Input Sensing:
a.
Press
ACTIVITY.
b.
Highlight the desired input icon and press
ENTER
to switch to that input.
c.
Press
MENU
, highlight
Inputs
, and highlight
Learn
to open the
Inputs > Learn
screen
for the device.
The first function highlighted in the
4.
Learn
screen
is always
Power On
. Aim the
TV’s
remote control
at the TV and press
ENTER
to begin learning for that
function.
When the
5.
Power On
text starts flashing, aim the
device’s
remote control at the TV and hold the
POWER
key until a check mark appears next to
Power On
.
If the text stops flashing before the check mark
•
appears, repeat the previous step.
To remove the key from NetCommand control,
•
press the
CANCEL
key while the key name is
highlighted.
Press the
6.
keys on the
TV’s
remote control
to highlight other keys on the list. Repeat steps
4 and 5 for each additional function you wish to
control through NetCommand.
Note:
Device keys in the far right column will be asso-
ciated with the remote control’s
MORE
key when
“learned.” See the table on page 59.
If the device has a separate
7.
POWER OFF
key, press
on the
TV’s
remote to highlight
Power Off
.
Repeat the earlier steps to “learn” the
POWER OFF
key.
If the device has no POWER OFF key, skip this step.
Press
8.
BACK
to finish NetCommand “learning” for the
current device.
From the New Device Found screen, highlight
NetCommand and press ENTER to open the Learn
screen.
Initial NetCommand Setup
Inputs > Learn screen
Key names marked with a
check have been “learned.”
Device-specific keys in the
rightmost column can be accessed
with the MORE key after “learning.”
Adding or Removing Device Keys from
NetCommand Control
Switch the TV to the device. Press
1.
ACTIVITY
, high-
light the device’s icon, and press
ENTER
.
Open the
2.
Inputs
menu and highlight the
Learn
icon.
When the
3.
Learn
screen displays:
To add keys:
•
Continue as described earlier
under “Initial NetCommand Setup” on this
page.
To delete keys:
•
Highlight the name of the key
you wish to delete and press
CANCEL
on the
TV‘s
remote control to clear the check mark.
