77
OCH754A
*2 For the detail of Heater control, refer to the service manual.
*3 4 degC (7.2 degF) up
*4 Depend on the error, heater may not operate please refer to SVZ service manual.
External static
pressure
Setting No.
35Pa (0.14in.WG)
50Pa (0.20in.WG)
70Pa (0.28in.WG)
100Pa (0.40in.WG)
150Pa (0.60in.WG)
2
3
1
2
3
Mode No. 08 Mode No. 10
1
1
2
2
2
Check
: Initial setting
(Factory setting)
External static
pressure
Setting No.
75Pa (0.3in.WG)
125Pa (0.5in.WG)
200Pa (0.8in.WG)
1
2
3
Mode No. 08 Mode No. 10
1
1
1
Check
: Initial setting
(Factory setting)
External static pressure setting for SVZ (Vertical, Horizontal left, Horizontal right position*).
External static pressure setting for PEAD.
* Regarding to down flow setting, please refer to down flow kit installation manual.
Function
Settings
No.
Mode
No.
Setting
: Initial setting
(Factory setting)
Filter sign
100h
1
2500h
07
(107)
2
No filter sign indicator
3
External static pressure
5/15/35/50Pa
(0.02/0.06/0.14/0.20in.WG)
08
(108)
10
(110)
1
2
Extra low
3
Fan speed during the
heating thermo OFF
Stop
25
(125)
1
Set fan speed
2
27
(127)
1
2
Detection of abnormality of
the pipe temperature (P8)
1
28
(128)
2
Set temperature in heating
24
(124)
mode *3
Available
Not available
Fan speed during the
cooling thermo OFF
Set fan speed
Stop
Available
Not available
Heater control *2
SEZ, SLZ :Set temp -4.5°F ON
SEZ, SLZ :Set temp -1.8°F ON
23
(123)
1
2
Check
SVZ-KP·NA
PEAD-A·AA
Ceiling suspended Multi position
Heater present
No heater present
PEAD, SVZ :Heater not operation in Defrost/Error
PEAD, SVZ :Heater not operation in Defrost/Error*4
11
(111)
Refer to the
table below
Refer to the
table below
Refer to the
table below
Refer to the
table below
Wired remote
controller
(RF thermostat)
1
2
(2) Functions available when setting the unit number to 01-03 or AL (07 in the case of the IR wireless remote controller)
• When setting functions for an indoor unit in an independent system, set the unit number to 01 referring to
4
setting the
indoor unit number.
• When setting functions for a simultaneous twin indoor unit system, set the unit number to 01 to 03 for each indoor
unit in the case of selecting different functions for each unit referring to
4
setting the indoor unit number.
• When setting the same functions for an entire simultaneous Twin-indoor unit system, set refrigerant address to AL
(07 in the case of the IR wireless remote controller) referring to
4
setting the indoor unit number.
<Table 3> Available functions and settings
12-2. SELECTING FUNCTIONS USING THE REMOTE CONTROLLER
Refer to "15-3. SERVICE MENU" and "15-5. FUNCTION SETTING" when selecting functions.
