11
*1 Perform programming to execute the following operation at start-up of the C
Controller module.
1) Turning ON Ym when battery voltage drop is detected.
Create a program so that Ym is turned ON by the QBF_Y_Out_BitEx
function when the "Built-in battery error status" of the QBF_ReadStatusEx
function turns to 1 (battery error occurrence).
2) Turning ON Yn at start of the user program.
Create a program so that Yn is turned ON to release interlocks at start of
the C Controller module user program.
*2 Perform programming to execute the following operation at start-up of the C
Controller module.
1) Turning ON Ym when battery voltage drop is detected.
Create a program so that Ym is turned ON by the QBF_Y_Out_BitEx
function when the "Built-in battery error status" of the QBF_ReadStatusEx
function turns to 1 (battery error occurrence).
2) Turning ON Yn at start of the user program.
Create a program so that Yn is turned ON to release interlocks at start of
the C Controller module user program.
3) Starting system processing after XM turns ON and the DC input signals is
established (after the DC input signal establishment time elapses).
Create a program so that the system processing is executed when the DC
input signal establishment time elapses after XM has turned ON (this can
be confirmed by the QBF_X_In_BitEx function).
(The DC input signal establishment time is a time from when RA2 turns ON
until the DC input signal is established 100%. Set the time to 0.5 s.)
However, when a voltage relay is used as RA2, it is not necessary to set
the DC input signal establishment time in the user program.
Summary of Contents for Q06CCPU-V-H01
Page 37: ......
