16
<Fig. 5.1.7>
<Fig. 5.1.9>
<Fig. 5.1.8>
4
Install the bottom case.
• Remove the sheath as shown in the figure at right, and route the remote con
-
troller cable behind the bottom case.
Install the bottom case.
■ Installation using a mounting block
• Secure at least two corners of the switch box with screws.
■ Direct wall installation
• Secure at least two corners of the remote controller with screws.
• Be sure to secure top-left and bottom-right corners of the remote controller
(viewed from the front) to prevent it from lifting. (Use wall anchor etc.)
5
Install the top case on the bottom case.
Two mounting tabs are at the top of the top case.
Hook those two tabs onto the bottom case, and click the top case into place.
Check that the case is securely installed and can not be lifted.
The controller is shipped with the front cover mounted to the top case.
Remove the front cover from the top case before installing the top case on the wall.
Refer to “
1
Uninstalling the front cover” on page 18.
5. Zone Remote Controller
<Fig. 5.1.6>
<Fig. 5.1.5>
3
Prepare the bottom case of the remote controller.
Take the following procedure only when performing direct wall installation and
running the remote controller cable along the wall.
• Cut out the thin-wall part on the cover (indicated with the shaded area in the
right figure) with a knife or a nipper.
Note:
Make sure that the hole edges are smooth and will not damage the wires.
To avoid damage to the controller, do
not overtighten the screws.
To avoid damage to the controller,
do not make holes on the controller
cover.
Important
60 (2-3/8)
6 (1/4)
Unit: mm (in)
Sheath
Wall
Should not
be lifted
Bottom case
Installation using a mounting block
Direct wall installation
Remote
controller
cable
Refer to
2
.
Mounting block
Roundhead
cross slot
screws
Seal the cable
access hole
with putty.
Wood
screws
Remote
controller
cable