14
Seal the gap between the cable
and the access hole with putty.
Use a cable cover.
Thread the main remote controller cable through the cable
access hole at the top of the main remote controller.
Check that the cover is
securely installed and not
lifted.
en
4. Electrical work
9. Fit the top case and the front cover onto the bottom case.
The top case assembly (fitted with the front cover at factory shipment) has
two tabs on top. Hook the tabs onto the bottom case and snap the top case
onto the bottom case into place. Check that the cover is securely installed.
Caution:
When the top case is correctly attached to the bottom case a click is heard.
If the front cover is not clicked into place it may fall off.
■ Direct wall installation (when routing the main remote controller cable along
the wall surface)
• Thread the main remote controller cable through the cable access hole at
the top of the main remote controller.
• Seal the gap between the cable and the access hole with putty.
• Use a cable cover.
■ Disassembling the top case and the front cover
(1) Remove the front cover.
Insert a flat head screwdriver into either of two open slots at the bottom of
the main remote controller and move the screwdriver handle downward as
shown. The engagement of the tabs will be released. Then pull the front
cover toward the front to remove the front cover.
(2) Remove the top case.
Insert a flat head screwdriver into either of two open slots at the bottom of
the main remote controller. The subsequent procedure is the same as that
of the front cover.
Caution:
Use a 5 mm- flat head screwdriver. Do not turn the screwdriver forcibly
while placing the blade in the slots. Doing so could break the covers.
<Fig. 4.2.10>
<Fig. 4.2.11>
<Fig. 4.2.12>
Summary of Contents for PAC-SIF051B-E
Page 62: ......
