- 5 -
4. Unit installation
Attach the unit to the metal control panel box using M4 screws as shown in Fig. 3-2.
4
Wiring
1. Cover Removal and Installation
Remove the three mounting screws and the cover.
Attach the corner to the unit by tightening the three screws indicated in Figure 4-1.
CAUTION
The unit should be attached on all four corners to prevent it falling down.
WARNING
• All electric work must be performed according to local regulations.
Improper electrical work may result in electric shock or fire.
• Be sure to shut off the power source of this unit and all other connected units before wiring.
CAUTION
Do not connect the AC power line to the M-NET and POWER (24VDC) terminal blocks of this device; otherwise, the unit may fail.
Refer to the AG-150A Installation
Manual for instructions on how to
install the unit inside the mounting
attachment A type (PAC-YG85KTB)
(sold separately).
M4 (field-supplied)
Fig. 3-2
M4 (accessories)
Fig. 4-1
00gb_WT05372X04_7.book Page 5 Monday, September 28, 2009 2:03 PM
