10
GB
6. Heater Installation
<PAC-BH01EHT-E>
Run the base heater along the groove on the unit base.
●
Install the base heater inside the unit by following the procedures (6)-1 through (6)-3 below.
(6)-1 Unscrew the screws as shown in the figure below.
Caution: To reduce the risk of injury, wear protective gear when installing the base heater.
Groove on the base
Heater mounting bracket
2
or
7
Base heater
Heater mounting bracket
1
,
6
Note: The figure shows a simplified view of the unit base without the components on it.
Heater mounting bracket
4
or
5
Heater mounting bracket
3
Unscrew each
screw that is for
the base leg and
accumulator
installation.
(1 pc. each)
For the LARGE Accumulator, remove
the screw (1 pc.).
For the SMALL Accumulator (see the
figure below), do not remove any screw.
Base heater installation position
SMALL Accumulator
LARGE Accumulator
Non Oil tank
WT06456X01.book Page 10 Friday, January 20, 2012 3:39 PM
