Mitsubishi Netcom User Manual
Rev 3 02/24/2009
31
2. Enter the IP address of the computer running the forwarder into one of the
available
Agent IP Address
edit fields. Set the delay to 0.
9.3 Configuring the Forwarder Agent to Shut Down Remote Computers
Perform the following steps to add remote shutdown agents to the Forwarder Agent:
1. On the computer running the forwarder agent, select
Start
>
Mitsubishi
DiamondLink
>
Configure Forwarder
. The following screen will be displayed:
2. Click the
Add Agent
button.
3. Enter the IP Address of the computer to be shut down.
Note: This computer must be running the Remote Shutdown Agent
software.
4. Enter the time (in seconds) the remote system should wait after it receives the
shutdown message until it initiates a system shutdown.
5. Click the
OK
button.
Repeat this process for each remote computer to be shut down.
To edit an existing agent, select the agent from the list and click the
Edit
button.
Modify the agent and click the
OK
button to save the changes.
To delete an existing agent, select the agent from the list and click the
Delete
Agent
button. Important! The forwarder service must be restarted in order for any
changes (add, edit or delete) to take effect. To restart the service you can either
reboot your computer or stop and restart the
DiamondLink Remote Shutdown
Agent Forwarder
service using
Start
>
Control Panel
>
Administrative Tools
>
Services
.
9.4 Configuring the Remote Shutdown Agents to Receive Messages from the Forwarder
Agent
Each shutdown agent must be configured to receive messages from the Forwarder Agent.
On the remote agent configuration screen, enter the IP address of the Forwarder Agent.
Make sure that you check the
Netcom
check box.