En-3
● OPERATING INSTRUCTIONS ●
Before operation:
Insert the power supply plug into the power outlet and/or turn the breaker on.
Outdoor unit
N
AME OF EACH PART
P
REPARATION BEFORE OPERATION
Remote controller
Outdoor units may be different in appearance.
*1 The manufacturing year and month is indicated on the spec name plate.
Air inlet
(back and side)
Refrigerant piping
Drainage hose
Air outlet
Drain outlet
Air fi lter
(Nano platinum fi lter)
Front panel
Indoor unit
Air cleaning fi lter
(Electrostatic anti-allergy
enzyme fi lter, option)
Operation indicator lamp
Remote control receiving section
Emergency operation switch
Page 4
Horizontal vane
Air outlet
Heat exchanger
Display section
Air inlet
Remote controller
holder
Signal transmitting
section
Distance of signal :
About 6 m
Beep(s) is (are) heard
from the indoor unit when
the signal is received.
Operation display
section
ON/OFF
(operate/stop)
button
Temperature buttons
Page 4
Operation select
button
Page 4
ECONO COOL
button
Page 6
FAN speed
control button
Page 5
Off-timer button
Page 6
On-timer button
Page 6
VANE control
button
Page 5
TIME set buttons
Pages 3, 6
Increase time
Decrease time
CLOCK button
Page 3
RESET button
Page 3
Lid
Slide down
to open
• Install the remote control-
ler holder in a place where
the signal can be received
by the indoor unit.
Only use the remote controller provided with the unit.
Do not use other remote controllers.
If two or more indoor units are installed in proximity to one another, an indoor
unit that is not intended to be operated may respond to the remote controller.
POWERFUL
COOL
button
Page 6
• Make sure the polarity of the batteries is correct.
• Do not use manganese batteries and leaking batteries. The remote controller
could malfunction.
• Do not use rechargeable batteries.
• Replace all batteries with new ones of the same type.
• Batteries can be used for approximately 1 year. However, batteries with
expired shelf lives last shorter.
• Press RESET gently using a thin instrument.
If the RESET button is not pressed, the remote controller may not operate
correctly.
• Press CLOCK gently using a thin instru-
ment.
Installing the remote controller batteries
Setting current time
1.
Press CLOCK.
3.
Press CLOCK again.
2.
Press the TIME buttons to set the
time.
Each press increases/decreases
the time by 1 minute (10 minutes
when pressed longer).
1.
Remove the front lid.
3.
Install the front lid.
4.
Press RESET.
2.
Insert the negative
pole of AAA alkaline
batteries fi rst.
Spec name plate *1
Spec name plate *1
JG79A934H01_en.indd 3
7/3/2014 3:33:40 PM
