6
3. Operation
■
About the operation method, refer to the operation manual that comes with each remote controller.
3.1. Turning ON/OFF
3.1.1. For wired remote controller
[ON]
[OFF]
Press the [ON/OFF] button.
The ON/OFF lamp will light up in
green, and the operation will start.
Press the [ON/OFF] button again.
The ON/OFF lamp will come off, and
the operation will stop.
3.1.2. For wireless remote controller
[ON]
■
Press the ON/OFF button
①
.
Note:
●
When the unit is restarted, initial settings are as follows.
Remote Controller settings
Mode
Last operation mode
Temperature setting
Last set temperature
Fan speed
Last set fan speed
Airflow up/down
Mode
COOL or DRY
Horiz. outlet
HEAT
Last setting
FAN
Horiz. outlet
[OFF]
■
Press the ON/OFF button
①
again.
Note:
Even if you press the ON/OFF button immediately after shutting down the operation is progress, the air conditioner will not start for about three minutes. This
is to prevent the internal components from being damaged.
3.2. Mode select
3.2.1. For wired remote controller
F1
F2
F3
F4
Cool
Room
Set temp.
Mode
Temp.
Fan
Fri
Press the [F1] button to go through the
operation modes in the order of “Cool”,
“Dry”, “Fan”, “Auto”, and “Heat”. Select the
desired operation mode.
Cool
Dry
Fan
Auto
Heat
•
Operation modes that are not available to
the connected indoor unit models will not
appear on the display.
What the blinking mode icon means
The mode icon will blink when other indoor units in the same refrigerant
system (connected to the same outdoor unit) are already operated in a
different mode. In this case, the rest of the unit in the same group can
only be operated in the same mode.
AAA
AAA
CLOCK
CHECK
RESET
SET
TEST RUN
MODE
FAN
VANE
LOUVER
min
h
AUTO START
AUTO STOP
ON/OFF
TEMP
①
②
③
④
2
3
4
(option)
3.2.2. For wireless remote controller
■
Press the operation mode (
) button
②
and select the
operation mode
2
.
Cooling mode
Drying mode
Fan mode
Heating mode
Automatic (cooling/heating) mode
Ventilation mode
Only indicated on the following condition
Wired remote controller used
LOSSNAY connected
►
■
Operation status memory
Remote controller setting
Operation mode
Operation mode before the power was turned off
Preset temperature Preset temperature before the power was turned off
Fan speed
Fan speed before the power was turned off
■
Settable preset temperature range
Operation mode
Preset temperature range
Cool/Dry
19 – 30 °C
Heat
17 – 28 °C
Auto
19 – 28 °C
Fan/Ventilation
Not settable
