En-3
• OPERATING INSTRUCTIONS •
• Make sure the polarity of the batteries is correct.
• Do not use manganese batteries and leaking batteries. The remote controller
could malfunction.
• Do not use rechargeable batteries.
• Replace all batteries with new ones of the same type.
• Batteries can be used for approximately 1 year. However, batteries with
expired shelf lives last shorter.
• Press RESET gently using a thin instrument.
If the RESET button is not pressed, the remote controller may not operate
correctly.
Before operation:
Insert the power supply plug into the power outlet and/or turn the breaker on.
• Press CLOCK gently using a thin instrument.
Operation indicator lamp
Remote control receiving section
Emergency
operation switch
Page 4
Air inlet (back and side)
Refrigerant piping
Drainage hose
Air outlet
Drain outlet
Horizontal vane
Vertical vane
Air outlet
Fan
Air
fi
lter
(Nano platinum
fi
lter)
Air inlet
Heat exchanger
Front panel
Outdoor unit
Installing the remote controller batteries
Setting current time
N
AME OF EACH PART
P
REPARATION BEFORE OPERATION
1.
Press CLOCK
4.
Press CLOCK again
2.
Press either the TIME button or
the TIMER buttons to set the
time.
Each press increases/decreases
the time by 1 minute (10 minutes
when pressed longer)
Indoor unit
Remote controller
Outdoor units may be different in appearance.
1.
Remove the front lid
2.
Insert AAA
alkaline batteries
3.
Install the front lid
4.
Press RESET
Air cleaning
fi
lter
(Electrostatic anti-al-
lergy enzyme
fi
lter)
Signal transmitting
section
Distance of signal :
About 6 m
Beep(s) is (are) heard
from the indoor unit
when the signal is
received.
Operation
display section
ON/OFF
(operate/stop) button
Temperature
buttons
Page 4
Operation
select button
Page 4
ECONO COOL
button
Page 6
FAN speed control
button
Page 5
LONG button
Page 5
WIDE VANE control button
Page 5
VANE control button
Page 5
TIME, TIMER set buttons
Pages 3, 6
Increase time
Decrease time
CLOCK button
Page 3
RESET button
Page 3
Lid
Slide the lid down to open
the remote controller. Slide
it down further to get to the
weekly timer buttons.
Display section
3.
Press the DAY button
to set the day
POWERFUL
button
Page 5
i-save button
Page 6
WEEKLY TIMER
set buttons
Page 7
Remote controller holder
• Install the remote
controller holder in a
place where the signal
can be received by the
indoor unit.
• When the remote
controller is not used,
place it in this holder.
Only use the remote controller
provided with the unit.
Do not use other remote controllers.
If two or more indoor units are in-
stalled in proximity to one another,
an indoor unit that is not intended
to be operated may respond to the
remote controller.