Mitsubishi Electric MR-G50J, Operating Instructions Manual

Page: 11 / 32

11
Cooking Timer
It can also be used as an alarm at the completion of cooking time.
The icon blinks during
the operation.
Time is displayed instead
of the present
temperature.
Press button to
set the timer.
Setting range is minimum 1 minute
up to maximum 99 minutes with 1-
minute increments. To set the timer
for 10-minute increments, hold down
the panel switch longer.
Press button to start.
Alarm sound will announce the completion
Any panel switch can be pressed to stop the alarm sound. (It
automatically stops after 1 minute, if no panel switch was pressed.)
QUICK
Press and hold and buttons
simultaneously for 1 second (until
a “beep” sound is heard).
The number
0
blinks on the display.
Follow the operation
explained on the left
To stop the timer halfway through the
operation, press button again.
The number returns to “0”. (It does not blink)
The timer mode is not released.
SELECT
QUICK
Energy-Saving operation
It automatically switches between “Energy-Saving
Operation Mode” and “Normal Operation Mode” to
minimize the energy consumption.
Press button.
comes on in the LCD section.
Re-setting
It re-sets all settings of “Temperature Control”, “Fast Cooling”,
and “Energy-Saving Operation” to the initial setting.
Also, it will cancel the timer mode.
Press button and hold down for about 3 seconds (until a
“beep” sound is heard)
There are no changes in temperature control for “Ice
Making Compartment” and “Versa Compartment”.
ECO
To
release
Follow the operation explained above
QUICK
Child Lock
It rejects any mischievous tampering or
unintentional pressing of control panel settings.
Press and buttons simultaneously and hold
down for about 3 seconds. (until a “beep” sound is heard)
turns on.
QUICK
ECO
To
release
Follow the operation explained above
SELECT QUICK
Short Notes for Users
●
If you select the soft freezing and then use the fast cooling
function, the temperature inside the compartment becomes
temporarily too low, freezing the food too hard. In such a
case, you may not cut it with a knife.
●
After fast cooling, the temperature inside the compartment is
too low and the values on the temperature display section may
be lower than the target values shown on pages 8 and 15.
●
Noise levels will rise while in the “Fast Cooling” mode.
●
In case of using “Cooking Timer” and “Fast Cooling”
concurrently, start “Fast Cooling” mode first followed by
“Cooking Timer” setting.
●
No other setting is available while using the “Cooking Timer”.
●
While using the “Cooking Timer”, control panel light stays “ON”.
Main Functions of the Control P
anel
To enter the Timer Mode
To
release
To set the time and start
PU8>M;9=g895996x>=
06.5.24, 5:02 PM 11