11
Display of the remote
controller does not
appear(
1
,
2
).
The remote control
signal cannot be
received if the remote
controller is not
operated near the air
conditioner (
1
).
d
d
d
d
d
Check the following.
1
Aren’t the batteries ex-
hausted?
2
Is the polarity (+, -) of
the batteries correct?
The air conditioner
cannot be operated.
d
d
d
d
d
Check the following.
1
Is the breaker turned
on?
2
Isn’t the fuse blown?
3
Isn’t the ON-timer set?
When a power failure
occurs.
d
d
d
d
d
Check the following after
the restoration of the
power.
If the air conditioner had
operated before the power
failure, as these models
are equipped with the auto
restart function, the air
conditioner should start
operating again. (Refer to
Description of “AUTO RE-
START FUNCTION” on
page 6.)
1
Does the air condi-
tioner start operating
again?
Cannot be cooled
or heated sufficiently.
d
d
d
d
d
Check the following.
1
Is the temperature set-
ting correct?
2
Isn’t the air filter dirty?
3
Isn’t the outlet of the out-
door unit blocked?
Even if the above items are checked, when the air conditioner does not recover from the trouble,
stop using the air conditioner and consult your dealer.
In the following cases, stop operation and consult your dealer.
•
The remote control signal may not be received in a room where an electronic ON/OFF type fluorescent lamp (inverter
type fluorescent lamp, etc.) is used.
•
In the region where the electric wave is weak, when the air conditioner is operated, noise may be generated in radio
reception.
•
When thunder is heard, stop operation and turn off the breaker. Otherwise, the electrical parts may be damaged.
BEFORE CONTACTING THE SERVICE REPRESENTA-
TIVE, CHECK THE FOLLOWING AGAIN
WHEN YOU THINK THAT TROUBLE HAS OCCURRED
Answer (not a malfunction)
•
This protects the air conditioner according to the instructions from the
microprocessor.
Please wait.
•
This sound is generated by the expansion/contraction of the front panel, etc.
due to change in temperature.
•
The air conditioner sucks in an odor adhering to the wall, carpet, furniture,
cloth, etc. and blows it out with air.
•
In DRY operation, the unit operates using the same refrigerant circuit as in
COOL operation. DRY operation time has to be reduced in order to lower
humidity without much room temperature decreasing. So the compressor
sometimes stops, and at the same time the indoor fan stops. This prevents
water condensed on the heat exchanger from evaporating again.
•
This is the sound of refrigerant flowing inside the air conditioner.
•
This is the sound of condensed water flowing in the heat exchanger.
•
This is the sound of the heat exchanger defrosting.
•
This sound is heard when the outside air is absorbed from the drain hose in
turning on the range hood or the ventilation fan and that makes water flowing
in the drain hose spout out. This sound is also heard when the outside air
blows into the drain hose in case the outside wind is strong.
•
When a ventilation fan or a gas cooker is used in a room, the cooling load
increases, resulting in an insufficient cooling effect.
•
When the outside air temperature is high, the cooling effect may not be suf-
ficient.
•
This is the switching sound in turning on/off the fan or the compressor.
•
When the air conditioner is operated in the COOL or DRY mode, if the opera-
tion continues with air blowing down for 1 hour, the direction of the air flow is
automatically set to position 1 to prevent condensed water from dropping.
•
In the heating operation, if the air flow temperature is too low or when de-
frosting is being done, the horizontal vane position is automatically set to
position 1.
•
During COOL and DRY operations, pipe or pipe connecting sections are
cooled and this causes water to condense.
•
In the heating operation, the defrosting operation makes water frozen on the
outdoor unit melt and drip down.
•
In the heating operation, water condensed on the heat exchanger drips down.
•
Please wait as the air conditioner is preparing to blow out warm air.
•
Defrosting of the outdoor unit is being done (Defrosting operation).
Since this is completed in 10 minutes, please wait.(When the external tem-
perature is too low and humidity is too high, frost is formed.)
•
This is the sound when the flow of refrigerant inside the air conditioner is
switched.
•
These models are equipped with an auto restart function. When the main
power is turned off without stopping the air conditioner with the remote con-
troller and is turned on again, the air conditioner will start operation auto-
matically in the same mode as the one set with the remote controller just
before the shutoff of the main power.
Question
The air conditioner cannot be operated
for about 3 minutes when restarted.
Cracking sound is heard.
The room smells strange.
The fan stops during the DRY operation.
The sound of water flowing is heard.
The sound as burbling is heard.
The room cannot be cooled sufficiently.
Mechanical sound is heard from the in-
door unit.
The air flow direction is changed during
operation.
Water leaks from the outdoor unit.
Air does not blow out soon in the heat-
ing operation.
The operation is stopped for about 10
minutes in the heating operation.
Hissing sound is sometimes heard.
The air conditioner starts the operation
only with the main power turned on,
though you do not operate the unit with
the remote controller.
