−
3
−
Mounting screws (5 x 30 Type 1 tapping screws)
…
6
Installation panel
…
1
Cord clip
…
1
Clip mounting screw
…
1
Product
Required items
Pre-installation checks
■
Checking the installation environment
Do not install in the following types of location.
(This may cause malfunctions.)
Outdoors
Locations where the temperature could be lower than 0
º
C.
Locations where there is a lot of dust
Locations where the temperature could be higher than 40
º
C
Locations where there is a lot of condensation
Locations where salt damage could occur
Vehicles (including ships and airplanes)
Locations where corrosive, neutral, or reductive gases are present
Near food or tableware
Kitchens
Locations where the appliance may come into direct contact with water
(Where there is a risk of water splashing)
Locations where the appliance is direct sunlight or strong light.
(May cause the sensor to malfunction)
Rooms that have a sterilization basin, swimming pools, bathrooms.
■
Check the appliance, accessories, and items required for installation
Main unit
Longer than 150mm
■
Prepare if required
Single wire for internal wiring
(Cable core: between 2.0mm
2
and 3.0mm
2
)
※
Not needed if the
internal wiring is
complete
Drain tank
Air fi lter
SCREW ANCHOR
…
6
※
Use on concrete walls
Wall reinforcement
※
Reinforces walls made
of materials other than
concrete
■
Check the heater settings and air speed settings. (Heater settings only for JSH2)
Check the heater ON/OFF settings and air speed HIGH/STANDARD settings with the customer beforehand.
(The customer cannot adjust the settings after installation is complete.)
Accessories
Pen
To mark position to insert metal
screw plugs in the wall
Screwdriver
