−
11
−
Test Run
Step
What to check for
Check
1
Check the power supply voltage
Is single
-
phase 220
-
240V power being used?
Incorrect power supply may cause malfunctions.
2
Turn the ground-fault circuit
interrupter on
Is the power lamp in the display on?
3
Insert your hands to check if air is
being blown.
Is the air blowing?
4
Insert your hands to check if warm
air is being blown.
(Only with the JT-SB216JSH2 type
when the heater is "ON".)
(The JT-SB216KSN2 model does not
have a heater)
Is warm air blowing?
( If the room temperature is above 30ºC, for safety reasons
the heater will not operate even if the heater switch is
turned on.
）
※
As the heater is a simple heater, if the room temperature
is less than 18ºC, the air may feel cold.
Is the heater lamp in the display on?
5
Is the appliance mounted securely without any vibration or
abnormal noises?
※
Do not turn the ground-fault circuit interrupter on while hands or other objects are inside the hand drying area.
※
If the display lamp fl ashes, turn the ground-fault circuit interrupter "OFF", check that all of the lamps on the display
section are off, and then wait for 1 minute before switching the ground-fault circuit interrupter back "ON".
HEAD OFFICE: TOKYO BLDG., 2
-
7
-
3, MARUNOUCHI, CHIYODA
-
KU, TOKYO 100
-
8310, JAPAN
AUTHORIZED REPRESENTATIVE IN EU:
MITSUBISHI ELECTRIC EUROPE B.V.
HARMAN HOUSE, 1 GEORGE STREET, UXBRIDGE, MIDDLESEX UB8 1QQ, U.K.
