Mitsubishi Electric E Series, Service Handbook

Page: 29 / 170

[
II
Restrictions ]
- 20 -
HWE1417B GB
[6] Configuring the Settings
<1> Making the settings
Use the LED display and the three push switches (SWP1 (↑), SWP2 (↓), and SWP3 (Enter)) to change the current
settings on the circuit board and to monitor various monitored values.
(1) Setting procedures
Take the following steps to set the push switches SWP1 through SWP3. These switches must be set after the dip
switch SW1 has been set.
The settings must be set only by a qualified personnel.
Normally a value of setting item appears on the display.
↓
Press SWP3 (Enter) to enable the configuration changes.
The current setting value will blink.
↓
The left figure shows that the current setting value is "60.0."
To decrease this value to 58.0, for example, press SWP2 (↓).
Press SWP1 (↑) to increase the value.
When the desired value is displayed (58.0 in the example at left), press SWP3 (Enter).
↓
The displayed value will stop blinking and stay lit.
A lit LED indicates that the new setting has been saved.
* Pressing SWP1 (↑) or SWP2 (↓) will change the blinking setting value, but the
change will not be saved until SWP3 (Enter) is pressed.
Press and hold SWP1 (↑) or SWP2 (↓) for one second or longer to fast forward
through the numbers.
SWP1
SWP3
Enter SWP2
SWP1
SWP3
Enter SWP2
SWP1
SWP3
Enter
SWP2
1
2
3
HWE1417B.book 20 ページ ２０１９年７月１６日 火曜日 午後３時４７分