Mitsubishi Electric CC-Link-AnyWire Bitty Bridge, User Manual

Page: 29 / 74

27
CHAPTER 4 CONNECTIONS
4
4.
1 CC-Link Side T
e
rminal Block
CHAPTER 4
CONNECTIONS
For compliance with the EMC and Low Voltage Directives, refer to the following.

Page 63, Appendix 1
Even when the compliance with the EMC and Low Voltage Directives is not required, use of an EMC-compliant configuration
may reduce the influence from external noise.
4.1
CC-Link Side Terminal Block
The NZ2AW1C1BY is handled as a remote device station on CC-Link. The CC-Link side terminal block is a connector-
type terminal block which is easily connected and disconnected.
Manufacturer: PHOENIX CONTACT GmbH & Co. KG (Contact: www.phoenixcontact.com)
Model: MSTB2,5/5-STF-5,08AU
Tightening torque: 0.2 to 0.3N

m
To tighten the connector, a flathead screwdriver having a tipped size of 0.6

3.5mm is required.
Before removing the CC-Link side terminal block, check that the fixing screws on both sides are completely loosened
(removed from the socket).
Pulling with excessive force while the fixing screws on both sides are still tightened may cause damage to the devices.
Before connecting the connector, check that there are no short circuits due to the disconnected or frayed wires. Then
tighten the screws at both sides securely. (Tightening torque: 0.2 to 0.3N

m)
The fixing screws are not tightened when shipped. Securely tighten the screws on both sides when connecting the terminal
block.
CC-Link side
terminal block