7
6.
2 Mbyte and 4 Mbyte modules have a row of three
switches along one edge (1 Mbyte, 6 Mbyte and 8
Mbyte modules do not have switches). The correct
position of these switches depends on which XEN-LS
model you have.
POSITION 2
POSITION 1
LOCATING
HOLE
If you have a XEN-LS 386SX-16 or XEN-LS 486SX-
20, all three switches must be in position 1 (that is, to
the
right, if viewed as in the illustration above); if you
have a XEN-LS 386SX-20, the switches must be in
position 2 (to the
left, if viewed as shown above).
7.
Position the module so that its three rows of pins
are aligned with the three connectors on the
motherboard. (The 1 Mbyte module has only two,
parallel rows of pins. Position this module so that
the locating hole is towards the
rear of the
machine.) Firmly but carefully, press the module
into place, making sure that you do not bend or
otherwise damage the pins.
8.
Refit the bridge assembly, expansion cage and
system unit cover.
9.
Use the SETUP configuration software to reconfigure
the system to account for the additional memory. (If
you are upgrading a diskless workstation, the network
administrator may do this for you, or else make a copy
of the SETUP software available over the network.)
The SETUP software is described in the
Reference/
SETUP Diskette User’s Guide.
