H a r d d i s k d r i v e s a n d m o d u l e s
4/4
1
2
Figure 4-4 Unplugging the Ribbon Cable from a Module
1.
Hard Disk Module Data Connector
2.
Ribbon Cable
Note
Note
One of the connectors, located underneath the cooling fan assembly, is less accessible
than the others. If it is difficult to unplug this connector in the electronics chamber, feed
the ribbon cable carefully through the centre spine opening. Then unplug the connector
in the disk chamber.
3.
Remove the four securing screws, as shown in the following diagram:
2
2
1
Figure 4-5 Removing a Drive Module
1.
Empty Disk Drive Module
2.
Securing Screws
4. Slide the module gently out. You will feel a little initial resistance as the
backplane power connector unplugs from its socket on the centre spine
of the server.
Summary of Contents for APRICOT FT4200
Page 1: ...FT4200 Owner s Handbook NATIONAL ACCREDITATION OFCERTIFICATION BODIES ...
Page 2: ...APRICOT FT4200 OWNER S HANDBOOK ...
Page 10: ...APRICOT FT4200 Section One Startup and operating Upgrading and expansion ...
Page 36: ...APRICOT FT4200 Section Two Detailed service Information for authorised engineers ...
