Mitsubishi Electric APRICOT FT4200, Owner'S Handbook Manual

Page: 21 / 124

S e t u p a n d o p e r a t i o n
1/11
To run the ECU
♦
Locally, press F2 to run the Flash Disk Utility during the hardware
boot sequence but before the operating system loads, remotely, run the
Flash Disk Utility via the SMA.
◊
You also can use the SMA to instruct the system to load the ECU
automatically (see the SMA User’s Guide). The Flash Disk Utility
menu then appears on the screen.
♦
Select “Run Configuration Utility” from the Flash Disk Utility menu.
In a short while you will be presented with a screen similar to this:
EISA Configuration Utility
Main Menu
Learn about configuring your computer
Configuring your computer
Set Date
Set Time
Maintain system configuration disk
Exit this utility
HELP
Help text will appear in
this box for whichever
topic is highlighted.
How to use the ECU
The Help text will provide most of the instructions you will need to use the
ECU. The following paragraphs briefly explain the general techniques for
navigating your way through the utility.
Using menus and selection screens
♦
To select an option from a menu or selection screen, use the UP or
DOWN ARROW key to move the highlight to the option and press
the ENTER key.
Note Note
The fact that the some of the sub-menu options are listed as numbered steps does not
necessarily imply that you must select them in numerical order every time you run
the ECU.
♦
Some screens contain vertical scroll bars on the right-hand edge, which
indicate that there is more information than one screen can
accommodate. You can use UP or DOWN ARROW to scroll through
the information. If you need to scroll quickly through a series of
screens, use PAGE UP or PAGE DOWN.
♦
Use the ‘escape’ key to return through the menu structure. If you have
made any changes you will be prompted to save them first, or warned
that you must save them or changes will be lost.