2 - 7 2 - 7
MELSEC-GOT
2 SYSTEM CONFIGURATION
POINT
• About the hardware version
Confirm the hardware version with the products rating plate.
(Products that the EMC directive applies to are marked with the CE mark logo.)
IN 100-240VAC 50/60Hz POWER MAX115VA
MODEL
A960GOT-EBA-EU
DATE
MADE IN JAPAN
LISTED 80M1
IND. CONT. EQ.
GRAPHIC OPERATION TERMINAL
MITSUBISHI ELECTRIC CORPORATION
BD992C082H01
CE mark logo
L R
Hardware version
0105LR
• About the connection destination device
If connecting to a PLC not from this company (MELSEC-Q series, MELSEC-QnA
series, MELSEC-A series), refer to the manual of the connected device (PLC,
microcomputer) for information about the applicability of the EMC directive.
2.3.4 When the communication module/board is used
If the EMC directive is applicable, use the communication module/board shown below.
(Available May, 2001).
If a communication module/board other than those shown below is used, it will not
apply to the EMC directive.
Connection format
Communication module/board
Bus connection
A9GT-BUSS (Hardware version C or later)
A9GT-BUS2S (Hardware version C or later)
RS-232C
communication
A9GT-RS2 (Hardware version B or later)
CPU direct
connection
RS-422
communication
A9GT-RS4 (Hardware version B or later)
RS-232C
communication
A9GT-RS2 (Hardware version B or later)
Computer link
connection
RS-422
communication
A9GT-RS4 (Hardware version B or later)
CC-Link connection
A8GT-J61BT13 (Hardware version E or later)
Ethernet connection
A9GT-J71E71-T (Hardware version C or later)
