CS38 / CS41 SELECT Chainsaw
18
Original Instructions Version July 16
CS38-41_130716
Hot Engine Start
1.
Set the switch (3) to “I” position.
2.
Pull out the choke knob (5), then push the choke knob back in, this will set the choke to
the hot start position.
3.
Apply the chain brake by pushing the chain brake (7) forwards.
4.
Pull the starter handle until the engine runs.
5.
Pulling the throttle lever slightly will reset the throttle control.
Disengage the chain brake by pulling the chain brake towards the front handle prior to
cutting.
Running In
During the first ten hours of work, avoid running the engine at maximum speed for a prolonged
period until all the components have bedded in. After the engine has been run in, it will reach its
maximum power. After two hours of work, check that all nuts and screws are securely fastened and
tighten if necessary.
Stopping the Engine
1.
Release the throttle lever and allow the engine to run at idle for half a minute.
2.
Set the ignition switch to the STOP position (“0”).
Except for an emergency, avoid
stopping the engine while at full throttle.
NOTE
