Mitox CS260TX, Operator'S Manual

Page: 20 / 40

CS260TX PREMIUM Chainsaw
20
Original Instructions Version November 16
CS260TX_141116
Checking the Oil Supply
After starting the engine, run the chain at medium speed and see if chain oil is sprayed as shown in
the figure below (1).
The chain oil flow can be changed by inserting a screwdriver in the hole on the bottom of the clutch
side. Turn the shaft counter-clockwise to increase the oil flow. Turn the shaft clockwise to decrease
the oil flow. Adjust according to your work conditions
Care and Maintenance of Your Chainsaw
• In order to maintain your chainsaw in good working order, perform the maintenance and
checking operations described in this manual at regular intervals. In the event that any part needs
to be replaced, please contact the nearest authorised service dealer for assistance.
• Always turn off the engine before performing any maintenance or checking procedures.
• When sharpening, removing, or reattaching the chain, be sure to wear thick, sturdy gloves and
use only appropriate tools and equipment to prevent injury.
• When replacing the chain or any other parts, be sure to use only genuine spare parts and
approved lubricants.