Mitox 260B, Operator'S Manual

Page: 14 / 26

260B Blower / 280BV Blower Vacuum
14
Original Instructions Version July 12
IMPORTANT !
A two-position “ON-OFF” switch located on the left of the machine handle grip controls the engine ignition.
Cold Engine Starting Procedure
1. 2.
3. Set the ignition switch to the ON position.
4. Slowly pull the recoil starter handle until engagement of the pawls with the flywheel is felt.
5. While holding the unit, pull out the starter rope firmly until engine fires (indicated by a ‘cough’
from the engine).
6. Push the choke rod back in (choke is open).
7. Pull the starter rope until the engine starts.
8. Allow the engine to warm up before use.
Prime the fuel system by repeatedly
depressing the fuel primer bulb
until no air bubbles are visible in
the fuel discharge line. Cold Engine Only. Choke the
engine by pulling the choke
control to the fully extended
position (choke is closed).