Miteq D-9301, Operation And Maintenance Manual, Page: 28 / 86

3-9
3.3.2.4 Device Address/Baud Rate Selection
The device address is set with a DIP switch on the rear panel.
S1, 2, 3, 4 and 5 select the five LSBs of the address in binary
(switch off = "1", switch on = "0", S1 = LSB.) The two MSBs are
permanently set to "10" and not available to the user.
The baud rate and parity are selected with switches S6, 7 and 8
in the following code (switch off = "1", switch on ="0").
S8 S7 Baud Rate
0 0 1200
0 1 2400
1 0 4800
1 1 9600
S6 Parity
0 Even
1 Odd
3.3.2.5 Programming Examples
The converter address is 41H (ASCII code A). The following are
typical commands and responses showing the ASCII printable
characters.
A. Set the frequency to 3725.000 MHz
Controller Command Converter Response
{AF3725000}0 {AF}a
or possible error code
{Ac}~
B. Status Faults Command - response indicates the
synthesizer alarm is in a fault condition.
Controller Command Converter Response
{A?}Z {A?100000}