Miteq D-9301, Operation And Maintenance Manual, Page: 18 / 86

2-1
SECTION 2
INSTALLATION
2.1 UNPACKING, STORAGE, RESHIPMENT
Carefully open the shipping container and remove the equipment.
Weight of the converter is approximately 30 pounds. Inspect the
equipment thoroughly and report any damage.
If the equipment is to be stored, it should be wrapped in plastic
and kept in a clean, dry place.
If the equipment is to be reshipped for any reason, wrap in heavy
plastic and ship in a heavy (275 lb. test), double-wall carton.
At least three inches of a solid packing material should be used
on all sides of the converter. The carton should be marked to
indicate that it contains fragile electronic equipment.
2.2 MOUNTING
The converter chassis is 19" x 22" x 3.5" panel height. Slides
are provided for mounting in a standard 19" (EIA) equipment rack.
The converter should be securely mounted.
2.3 TURN-ON PROCEDURE
After mounting, make all external connections per Table 2-1.
Refer to Section 1 for the physical configuration of the
converter.
Apply power to the converter using the front panel power On/Off
switch.
Allow one half hour minimum for oven warm-up in the internal
crystal oscillator.
All LO fault lights should be off.
System is now operational.