5606 Wireless Handset User Guide
34
a Soft key” on page 28.The Soft/Hot key then enables/disables the alarm. Pressing the Soft
key, or pressing and holding the Hot key toggles the alarm. The “Man-down alarm” icon displays
to indicate that the No-movement alarm is enabled.
Send man-down alarm
The Man-down alarm goes off when the handset is tilted more than 45 degrees for a preset
time (the default is 30 seconds), for example if you fall. Before the alarm is activated, a warning
signal sounds and the “Man-down alarm on” icon flashes. If you do not cancel the alarm by
pressing a key (or the headset button if parameter is set),the alarm is sent and the
“No-movement/ Man-down Alarm” is shown in the display.
Activate the man-down alarm again
After a no-movement alarm has been sent, alarm function can be reset by moving the handset
to upright position or pressing a key.
Acoustic Localisation Signal
A parameter in the handset determines whether an Acoustic Localisation Signal (ALS) should
sound after a no-movement and man-down alarm. The ALS is silenced by pressing the Mute
button.
Delay Time before Warning for No-movement and Man-down Alarms
Your administrator can set the time before the warning for no-movement and man-down alarms
to be delayed for ten minutes, that is, no-movement and man-down conditions will not be
detected during that time. When the time runs out, the warning signal sounds. Press the Mute
button to delay the time to next warning for another ten minutes.
Alarm with Data
Additional data can be sent along with an alarm, for example, a location code.. The data must
be manually defined and stored by the user. To use the function, one Soft/Hot key in the handset
must be defined as a shortcut to the menu “Edit alarm data”, see “Edit a Soft key” on page 28.
The stored data is then added to all types of alarm at transmission. This is a system-dependent
function.
Note:
Even if the handset is locked (Phone Lock or Key pad lock), you can press a key
to reset the warning signal.
Note:
The alarm button can not be used to reset the warning signal.
Note:
If the vibrator function is enabled and the Man-Down alarm is triggered, the alarm
signal is interrupted to sample the movement sensor. To avoid interrupting the alarm
signal, set the ringing period in the ICP to the minimum acceptable time, and the alarm
warning timer to a maximum acceptable time. See your administrator.
