Safety, Operation, & Maintenance Manual
Linear Cut Processing Systems
Operation
001128
11
Optional Software Buttons (For Optional Equipment)
Some buttons described here are only on machines built in 2022 or later (generation 2).
•
Infeed Loader > Stop
– Stops the infeed conveyor.
•
Infeed Loader > Reverse
– Runs the infeed conveyor in reverse away from the infeed pusher assembly.
•
Infeed Loader > Forward
– Runs the infeed conveyor in a forward direction toward the infeed pusher assembly.
•
Outfeed > Conveyor Motor
– Turns the outfeed conveyor motor on.
•
Outfeed > Kicking Far/Near
– An option available to certain models is the existence of multiple kickers.
This button toggles the outfeed kicking system to either use the “Near” kickers closest to the central operator of
the system or the “Far” kickers furthest from the main operator location.
•
Outfeed > Test Kickers (Out/In)
– Used to for testing purposes only to check functionality of all pneumatic
kicking mechanisms. Pressing “Test Kickers (Out)” will execute all kickers to extend out. Pressing “Test Kickers
(In)” will retract the kickers back to their normal position. (*Note: The system does not allow running the
outfeed with the kickers extended out nor should the operator attempt to run the system with the kickers
extended out).
•
Outfeed > Speed (Medium/Fast)
– An option available to certain models is the existence of multiple speeds.
Used to switch the conveyor speed to one of two speeds: “Medium” or “Fast”.
*Note: Speed controls of this button are not relevant when in Cut Set Operations Mode. When in Cut Set
Operations Mode, speeds are determined by each material type in the Materials Library settings of the software.
