17
5> INPUT NAMES:
All input names are fully editable.
Explanation : The rear panel is labeled Optical IN 1, IN 2, IN 3, etc. These are the default names
used by the firmware, however, the displayed name may be changed as the user requires to make
it easier to identify an audio source.
For example, if a satellite receiver is connected to the Optical Input 1, this input could be renamed
to 'SAT'. Input names can be up to ten characters long.
EDITING AN INPUT NAME
Press the VOLUME/MENU knob for 5 seconds.
Using the VOLUME/MENU knob, locate item 5, "INPUT NAMES" and select by pressing.
Rotating the VOLUME/MENU knob, locate the input name to be edited, again, press the select
button.
The display will now show:
EDIT :<input name>
ALIAS :<Original name>
Notice that the first letter of the input name is flashing as a block.
To change the letter, press select. The letter will now be underlined.
Rotating the INPUT/NAV Knob will scroll through the available letters and symbols.
These are:- # ABCDEFGHIJKLMNOPQRSTUVWXYZ0123456789\-+:,.
When the required letter or symbol has been located, press the Select Button. This will return the
display to a flashing block. The INPUT/NAV knob can now be used to locate the next letter to edit.
Repeat the process until the name is displayed as required.
Finally, press the VOLUME/MENU button for 5 seconds to exit the MENU function. During the edit
process, the original name (as used on the rear panel) is shown as ALIAS for reference.
