R000226 BP1 Automation
19
v.0.1 03/21
Now select GPO 5 through 8 in turn, and ensure that the default position is set to LOW. If
you want to test the action of each GPO, press the TOGGLE button. You should hear a
relay click on the BP1 board and see its corresponding indicator LED illuminate briefly.
10. Once the GPOs are configured correctly, you now need to add the commands to
trigger them to the projector’s preset macros that require their use. The four projector
GPO functions that the BP1 uses to trigger external devices are shown in Figure 6-13.
GPO
Output
Function
GPI 1 through 4 are not used by the
BP1
5 Masking open (to scope)
6 Masking closed (to flat)
7 XL Mover to 2D position
8 XL Mover to 3D position
Figure 6-13
If this is a 2D-only house and no XL Mover is installed, you can ignore 7 and 8.
11. Navigate to Configuration
→
Presets, and then click the edit button for the preset
macro you wish to modify. In this example, we are going to add the “XL Mover to 3D”
GPO command to one of the 3D macros.
Figure 6-14
