MIRKA 1230 M AFC, Operating Instructions Manual

Page: 94 / 396

94
Mirka® Dust Extractor • 1230 M • 230 V / 100–120 V • PC & AFC
en
2.4 In explosive or inflammable atmosphere
CAUTION
This machine is not suitable for use in explosive or inflammable atmospheres or where such atmospheres are likely to
be produced by the presence of volatile liquid or inflammable gas or vapour .
3. Control / Operation
CAUTION
Damage due to unsuitable mains voltage . The appliance can be damaged as a result of being connected to an
unsuitable mains voltage .
• Ensure that the voltage shown on the rating plate corresponds to the voltage of the local mains power supply .
3.1 Starting and operating the machine
Check that the electrical switch is switched off (in position 0) . Check that suitable filters are installed in the machine .
Then connect the suction hose into the suction inlet on the machine by pushing the hose forward until it fits firmly
into the inlet . When used for dust extraction together with a dust-producing tool, connect the end of the suction hose
using an appropriate adapter . Connect the plug into a proper electrical outlet . Put the electrical switch into position I in
order to start the motor .
Turn to I: Activate the dust extractor .
Turn clockwise for speed control .
Turn to 0: Stop the dust extractor .
Turn to sander: Activate Auto-On/Off .
Operation – turn counter-clockwise for speed control .
Turn to I: Activate the dust extractor .
Turn to
: Stop the dust extractor . Permanent power on socket .
Turn to I: Activate Auto-On/Off operation .
Turn to I + AFC Off: Activate the dust extractor with deactivated Auto Filter Cleaning .
Turn to Off: Activate Auto-On/Off operation with deactivated Auto Filter Cleaning .
Speed control operation on separate rotary knob .
The hose diameter and the setting for suction hose diameter must be the same: Ø 21, 27, 32, 36, 38 mm .
3.2 Auto-On / Off socket outlet for power tools
CAUTION
Appliance socket
The appliance socket is designed for electrical auxiliary equipment; see technical data for reference .
• Prior to plugging in an appliance, always switch off the machine and the appliance that is to be connected .
• Read the operating instructions for the appliance to be connected and observe the safety notes contained in these .
An earthed appliance socket is integrated in the machine . An external power tool can be connected there . The socket
features permanent power on when the switch is set to the
position, i .e . the machine can be used as an extension
cord .
In position , the machine can be switched on and off from the connected power tool .
Dirt is picked up from the source of dust immediately . To comply with regulations, only approved dust-producing tools
should be connected .
The maximum power consumption of the connected electrical appliance is stated in the “Specifications” section .
Before turning the switch to position
, ensure that the tool connected to the appliance socket is switched off .