MIRKA 1230 M AFC, Operating Instructions Manual

Page: 96 / 396

96
Mirka® Dust Extractor • 1230 M • 230 V / 100–120 V • PC & AFC
en
Before emptying the container, unplug the machine . Disconnect the hose from the inlet by pulling out the hose .
Release the container clamps by pulling them outwards so that the motor top is released . Lift the motor top off the
container . Always empty and clean the container and water level limit system after picking up liquids .
Empty by tilting the container backwards or sideways and pour the liquid into a floor drain or similar . Refit the motor
top on the container . Secure the motor top with the container clamps . Sudden movements can accidentally trigger
the water level limiting device . Should this happen; turn off the machine and wait for 3 seconds to reset the device .
Continue to operate the machine afterwards .
3.8 Dry pick-up
CAUTION
Picking up environmentally hazardous materials . Materials picked up can present a hazard to the environment .
• Dispose of the dirt in accordance with legal regulations .
Unplug the machine before emptying after dry pick-up . Release the container clamps by pulling them outwards so that
the motor top is released . Lift the motor top off the container .
Main filter: Check the filter . To clean the filter you can brush or wash it . Wait until the filter is dry before re-starting dust
pick-up .
Dust bag: Check bag to ensure the fill factor . Replace dust bag if necessary . Remove the old bag . The new bag is fitted
by passing the cardboard piece with the rubber membrane through the vacuum inlet . Make sure that the rubber
membrane passes the raised part of the vacuum inlet .
After emptying: Close motor top on the container and secure the motor top with the container clamps . Never pick up
dry material without having a filter fitted in the machine . The suction efficiency of the machine depends on the size
and quality of the filter and dust bag . You should therefore only use an original filter and dust bags .
4. After using the machine
4.1 After use
Unplug the machine from the socket when the machine is not in use . Wind up the cord starting from the machine . The
power cord can be wound up around the motor top or the container, or hung from the hook provided, or some other
fastener .
4.2 Transport
• Before transporting the machine, close all the container clamps .
• Close the inlet with the inlet cap .
• Do not tilt the machine if there are liquids in the container .
• Do not use a crane hook to lift the machine .
• Do not lift the machine by the trolley handle
4.3 Storage
CAUTION
Store the appliance in a dry place, protected from rain and frost . The machine must be stored indoors only .
4.4 Accessory and tool storage
For convenient transport and storage of accessories or tools, integrated rails are provided on the side of the machine,
which allow fastening with straps or some other means . A flexible strap and hooks are included at the back of the
machine for hanging the suction hose or mains cable . For instructions, see quick reference guide .