1) Use the bad SD card insert to video recorder slot,the car
ignition, and close the doors (or press the manual/auto button),
waiting for the recorder automatically shutdown after over 2 0
seconds, press the "Power" button . And reboot the system.
2)When the screen appears "Welcom" interface,manualpop up the SD
card quickly.
don’t
3)When the screen is blue and display "Card
Errorr" prompt characters, press the card
inside the video recorder slot once again
quick
.
4) Recorder into the main interface, choose
"Settings" function, according to the "OK"
button, enter into the setting interface
(Figure41).
5) Affter into the setting interface, choose the
"format", according to the "OK" button,
enter into the memory card select interface
(Figure 42).
6) And affter into the memory card select
interface, select "SD Card", according to
the "OK" button, choose "Yes", then press
the "OK" button (Figure 43).When the
screen display "funnel "icon that is working
to format implement(have a longer time).
7) When the screen display "Successful" red
characters, said SD card format has been
successful as FAT 3 2 format, from this
point should be shutdown, and the card in
the computer press over the operation to
re-format.
Figure 41
Figure 42
8) When the monitor display "Memory
Errorr" prompt red characters, said SD
card not format ,and now need to repeat 1 -
6 of the steps, or can’t be repeated three
times to format, the SD card can only send
to the factory repair
.
2 To force repair SD card
Figure 43
20
1. The product of the wiring and installation needs of the professional
skills and experience, with professional staff to carry out the
installation of wiring and installation to ensure the safety of this
product is installed.
2. The product can only be applied in the operating voltage 12 V - 36V
of vehicles.
3. The installation of wiring when drilling will not touch, damage,
airway obstruction and wires, so as not to cause an accident.
4. When all the wires are connected ,must to use the electronical
wrap plastic sheets to bind the bare copper wire, not short-circuit
with the other wires, take good wires application truss ties, so that
they do not curl or entanglement in order to avoid sharp or sharp
vehicle parts cause electrical damage have accidents outside.
tion of cameras, to choose the location and camera wire
put in inconspicuous places hat the passengers is not easy damage;
it is not easy for people to damage and pressure off;adjustable
camera angle to the right point of view, then fixed it , attached seals;
from the camera equipped with infrared light can not exceed 1 2
lights.
6. When installation of recorder, it must be installed on the local of
waterproof and moisture.
7. The wiring should be first connect to the power and signal line of
the camera and microohone; followed 'Signal Bus' ignition, video
control, reversingand so on the signal lines,then the last connect is
recorder, and input of power supply box.
8. Don’t install the microphone in the wind, because the microphone
is the higher sensitivity.
9.When installation of Menci , attention away from the action is less
than 10 mm, after closed the door the distance of Menci can not be
more than 10 mm, or else they might make the video recorder in a
long working state; Menci wiring, the one side of the Menc connect
to the video control lone,fllowed the other side of Menci shoud
connect to the power to prevent a short circuit occurred on Menci.
5. The installa
I
、
Ins tal lat ion sp eci ficat ion an d Rul es
01
(
6
)
T
o
the format 100%would show this SD card is good and formatted
successful.
