Mirapoint RazorSafe 170, Hardware Manual

Page: 37 / 76

Expansion Cards
37
Expansion Cards
Expansion Card Installation Guidelines
Your appliance supports one PCIe Generation 2 expansion card installed on an
expansion-card riser.
◆
The expansion-card slot supports full-height and half-length cards.
◆
The expansion-card slot is not hot-swappable.
Installing an Expansion Card
c
Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product
documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized is not covered by your warranty.
Read and follow the safety instructions that came with the product.
To install an expansion card:
1.
Unpack the expansion card and prepare it for installation.
For instructions, see the documentation accompanying the card.
2. Power off the appliance, including any attached peripherals, and disconnect the
appliance from the electrical outlet.
3.
Open the appliance. See Opening the Appliance on page 30.
4.
Open the expansion-card latch and remove the filler bracket ( Figure 10 on
page 38).
5. Holding the expansion card by its edges, position the card so that the card-edge
connector aligns with the expansion-card connector on the expansion-card
riser.
6. Insert the card-edge connector firmly into the expansion-card connector until
the card is fully seated.
7.
Close the expansion-card latch ( Figure 10 on page 38).