Miranda Kaleido-X, Installation Manual

Page: 19 / 43

13
Kaleido-X (4RU)
Hardware Description & Installation Manual
The following table lists the purpose of each connector associated with card control.
The pinout for the RS-422 signal on the RJ-45 connector on the output cards’ rear panel,
and the wiring diagram for an appropriate adapters, are shown here:
Standard wiring between multiviewer and devices wired to SMPTE “slave” specification (e.g. most
routers, Ross Synergy switchers, Nevion ETH-CON)
Connector label Connector type Function
LTC IN 1 BNC Time code input #1
LTC IN 2 WECO Time code input #2
LTC IN 3 WECO Time code input #3
ETHERNET RJ-45 100 Base-T Ethernet connection
USB USB A Connect a mouse, keyboard, or USB key for software
upgrade or data backup
There are three other USB ports accessible on the front of
the card that serve the same functions.
RS-422 RJ-45 (see note
below) Connect to an RS-422 (SMPTE ST 207, EBU-3245) or
RS-485 device or network
Note:
The Kaleido-X’s RS-422 ports have an RJ-45 connector in order to
preserve space on a busy panel. The RS-422 interface specifies a DE-9
connector, so if you are using this interface, you will require a DE-9-to-RJ-45
adapter. Miranda supplies two adapter models, correctly wired for this
application: a straight adapter (part no. 1737-3000-102), and a crossover
adapter (part no. 1792-3700-100).
Pinout of each RS-422
port’s RJ-45 connector
on the multiviewer
Pinout of straight adapter
(Miranda part no. 1737-3000-102)
RJ-45 DE-9 male DE-9 female
Pinout of RS-422
connector on SMPTE
slave device